LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 1988 >> Lancer Base, 2.2 D, Standard >> Repair and Diagnosis >> Engine Performance >> System >> 2.2L/2.5L TBI Tests W/Codes >> No Start Tests >> NS14 - Checking System For Fault Codes

NS14 - Checking System For Fault Codes

  1. Connect DRB II to engine harness connector. Erase fault codes. Turn ignition switch to "RUN" position for 5 seconds. Crank engine for 7 seconds and return ignition switch to "RUN" position for 5 seconds. Put system in Diagnostic Test Mode. Record all codes.
  2. If no code 88 or 00 (system power circuits) is displayed, go to NS15  . If codes 88-11-12-55 (distributor pick-up circuit) is displayed, go to NS16  . If codes 88-42-55 (auto shutdown relay pull-in coil circuit) is displayed, go to NS17  .
  3. If codes 88-12-14-22-24-55 or 88-12-14-22-23-24-55 are displayed, repair Black/Light Blue wire in SMEC 60-pin connector cavity No. 4 for an open circuit. If code 88-12-44-55 is displayed, go to NS18  . If codes 88-12-55 (no fault codes) are displayed, go to NS19  .
scientia non olet · About LEMON Manuals