Neutral Safety Switch
- With transaxle linkage properly adjusted, switch should allow starter operation in Park and Neutral only. To test switch, remove wire connector and test for continuity between center pin of switch and transaxle case. Continuity should exist only when transaxle is in "P" or "N".
- Check for continuity between 2 outer pins. Continuity should exist with transaxle in Reverse, only. There should be no continuity between either outside pin and the transaxle case.NOTE: Ensure gearshift linkage is properly adjusted before replacing a switch that tests bad.
- To replace, remove switch from case and allow fluid to drain. Move selector lever to Park and Neutral positions and check that switch operating fingers are centered in switch opening. Install new switch and seal. Retest switch for continuity and add transaxle fluid.
When installing new switch, tighten to 24 ft. lbs. (33 N.m).