LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 1987 >> Mini Ram Van Base, 2.2 C, Standard >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Servicing - A/T >> Adjustment >> Low-Reverse (Rear) Band

Low-Reverse (Rear) Band

  1. Drain transaxle fluid and remove oil pan. Apply 30 psi (2.1 kg/cm2 ) air pressure to low-reverse servo and measure gap between band ends. If less than .080" (2.0 mm), band is excessively worn and should be replaced.
  2. To adjust band, loosen lock nut approximately 5 turns and tighten adjusting screw to 44 INCH lbs. (5 N.m). Back off adjusting screw number of turns listed. See LOW-REVERSE BAND ADJUSTMENT  . Hold screw in position and tighten lock nut.
    LOW-REVERSE BAND ADJUSTMENT

    Application Back Off Screw
    A-413/A-470 3 1/2 Turns
scientia non olet · About LEMON Manuals