LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 1983 >> Rampage Base, Automatic >> Repair and Diagnosis >> Engine Performance >> System >> Choke - Electric Assist >> Testing >> Control Switch Test

Control Switch Test

  1. Before starting test, check test light by connecting it to battery terminals. Note light intensity.
  2. Before starting engine, detach ignition harness electrical connector from heater control switch.
  3. Connect test light to load (choke) terminal of control switch and to ground.
  4. Start engine and allow it to reach normal operating temperature.
  5. Apply 12 volts to ignition harness terminal of control switch. If test light does not light or have the same original intensity, replace defective control switch.
scientia non olet · About LEMON Manuals