LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 1968 >> P200 Base, Not Available Trans >> Repair and Diagnosis >> Engine Performance >> Fuel Delivery >> Electric Assist Choke >> Testing >> Choke Control Switch

Choke Control Switch

  1. Check test light by connecting it between battery terminals of car battery. Take careful note of intensity of bulb.
  2. before starting engine, remove "BAT" electrical connector from control switch. Connect test light to load (small) terminal of control switch and to ground.
  3. Start engine and allow it to reach normal operating temperature. Then apply 12 volts to "BAT" terminal of control switch as follows; test light must light and have same intensity as step one above. If intensity is lower, unit is defective and must be replaced. Test light must light and if it has same intensity as step one, it may remain lit for only a few seconds or it may remain lit for a long duration, but must not remain lit for longer than five minutes. If it remains lit for longer than five minutes, control switch is defective and must be replaced.
scientia non olet · About LEMON Manuals