LEMON Manuals: Even more car manuals for everyone
Home >> Daewoo >> 2000 >> Nubira SE, Standard >> Repair and Diagnosis >> Steering >> Steering Column >> Overhaul >> Standard Steering Column >> Disassembly

Standard Steering Column: Disassembly

  1. Remove steering column from vehicle. Remove steering wheel from steering column. Remove upper steering shaft spring and thrust washer. See Figure . Remove shear bolts, shear bolt washers, and ignition switch housing from steering column housing as follows: See Figure .
    • Use a metal punch to start drill head.
    • Drill off head of shear bolts clown to steel shear bolt washers with a 6.5 mm (1/4 inch) drill bit.
    • Separate washers and ignition switch housing from column housing.
    • Remove threaded end of shear bolts from ignition switch housing with locking pliers.
      NOTE: After drilling and removing threaded end of shear bolts, all metal shavings must be cleaned from all parts.
  2. Remove turn signal switch housing screws. Remove upper part of turn signal switch housing assembly, then remove lower part of turn signal switch housing assembly. See Figure . Remove retaining ring by compressing spring retainer and upper bearing spring with non-tilt lock plate adapter J-42460 and lock plate compressor J-23653-A. See Figure .
  3. Remove column housing from jacket assembly. See Figure . Remove steering shaft assembly from upper end of jacket assembly. Remove washer and retaining ring. See Figure . Press out steering column housing bearing using remover/installer KM-108. See Figure .
scientia non olet · About LEMON Manuals