LEMON Manuals: Even more car manuals for everyone
Home >> Daewoo >> 2000 >> Leganza SE, Automatic >> Repair and Diagnosis >> Steering >> Power Steering >> Testing >> Steering Rack Bench Test >> Removal, Set-Up & Testing

Removal, Set-Up & Testing

NOTE: Pressure checks or pressure and flow checks may also be conducted using this setup.
  1. Disconnect and remove power steering gear. Place power steering gear on a bench next to vehicle. Disconnect pressure line at point where hose connects to pipe. Extend this line to reach power steering gear on bench.
  2. Disconnect return line from the power steering fluid reservoir. Extend this line to reach power steering gear on bench. Connect power steering pipes to power sterling gear. Start engine and allow it to idle for 10 seconds. Check power steering fluid level. Start engine and turn rack and pinion stub shaft a full turn in each direction. Hold shaft against each stop for 5 seconds. Inspect for possible leak points.
scientia non olet · About LEMON Manuals