Pressure Sensor
WARNING: This page is about a different car, the 2025 Chrysler Pacifica. However, it is still accessible from the selected car via links, so may be relevant.
REMOVAL
- Disconnect the wire harness connector from the pressure sensor.
- Remove the pressure sensor from the Rear Drive Module (RDM) housing.
1 - Pressure Sensor
INSTALLATION
Follow the removal procedure in reverse for general reassembly of the components on the vehicle. The steps listed below are calling out specific procedures that should be followed during installation.
- Replace the pressure sensor with pre-applied sealant to the threads.
- Tighten the pressure sensor to the proper torque specifications. Refer to TORQUE SPECIFICATIONS .