Fuel Pump Control Module (FPCM)

REMOVAL 

1. Disconnect and isolate the negative battery cable.
2. Remove the trim from the left rear quarter panel to access Fuel Pump Control Module (FPCM), which is located on the forward part of the left rear wheel housing.. Refer to PANEL, QUARTER TRIM, REMOVAL AND INSTALLATION .
3. Disconnect the body wire harness connector from the FPCM.

   Courtesy of CHRYSLER GROUP, LLC

   1 - Fasteners

   2 - Wire Harness Connector

4. Remove the fasteners that secure the FPCM to the wheel housing.
5. Remove the FPCM from the vehicle.

INSTALLATION 

Follow the removal procedure in reverse for general reassembly of the components on the vehicle.