Throttle Body: Installation: 3.6L
- Check the condition of the throttle body-to-intake manifold seal (1). The seal can be reused if not damaged.
- Clean the mating surfaces of the throttle body and intake manifold.
- Install the Electronic Throttle Control (ETC) (2). Tighten bolts (3) in a crisscross pattern sequence to the proper torque specification. Refer to FUEL INJECTION, GAS, TECHNICAL SPECIFICATIONS .
- Connect the ETC wire harness connector (1) and attach the ETC wire harness clip to the housing (4).
- Install the air inlet hose assembly (5) onto the ECT (2) and securely tighten clamp.
- Install the air inlet hose assembly (5) onto air cleaner housing (3). and seat retaining grommet onto the ball stud (4) then securely tighten clamp.
- Connect the Inlet Air Temperature (IAT) sensor wire harness connector (1).
- Install the engine cover (1).
- Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
- A Scan Tool may be used to learn electrical parameters. Go to the Miscellaneous menu, and then select ETC Relearn. If the relearn is not preformed, a Diagnostic Trouble Code (DTC) will be set. If necessary, use a scan tool to erase any Diagnostic Trouble Codes (DTCs) from PCM.