LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2019 >> 300 C >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Cooling System >> Engine >> Fan, Cooling >> Installation >> 5.7/6.4L Single Fan

5.7/6.4L Single Fan

NOTE:

If replacing the fan blades. The dual fan blades can be replaced separately from the motor. Single motor fan blades are balanced to the motor and must be replaced as a fan/motor assembly.

GC0144489Courtesy of CHRYSLER GROUP, LLC
CAUTION:

When installing the cooling fan assembly, care must be used so that the fan shroud does not contact the radiator or the radiator fins. Damage may  cause leaking.

  1. Install the radiator cooling fan assembly (1) in vehicle.
  2. Align the lower cooling fan assembly mounting tabs (1) with the radiator mounts (2).
  3. Tighten the lower radiator support bolts to the proper specification. Refer to TECHNICAL SPECIFICATIONS .
  4. Install the lower engine belly pan. Refer to BELLY PAN, INSTALLATION .
  5. Remove support and lower vehicle.
    GC0144488Courtesy of CHRYSLER GROUP, LLC
  6. Install the cooling fan assembly mounting bolts (3). Tighten to the proper specification. Refer to TECHNICAL SPECIFICATIONS .
  7. Connect cooling fan wire harness connector (1).
  8. Install the air cleaner body. Refer to INSTALLATION .
  9. Connect the negative battery cable.
  10. Operate engine until it reaches normal operating temperature. Check the fan for proper operation.
scientia non olet · About LEMON Manuals