Module, Drivetrain Control (DTCM): Installation

Courtesy of CHRYSLER GROUP, LLC

1. Slide the Drive Train Control Module (3) on the mounting stud (6) and over mounting stud (5).
2. Install mounting fasteners (2 and 4) and tighten them to the proper specification. Refer to TECHNICAL SPECIFICATIONS .
3. Secure the drivers footwell carpet back to its installed position.
4. Install the cowl side trim panel. Refer to PANEL, COWL TRIM, INSTALLATION .
5. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.