Diagnostic Test

CHECK FOR AN ACTIVE DTC
1. With the scan tool, read Electronic Steering Lock (ESL) DTCs and record on the repair order.
2. Record the Environmental Data and any DTCs.
3. With the scan tool, erase DTCs.
4. Using the recorded Environmental Data, along with the When Monitored and Set Conditions above, operate the vehicle in the conditions that set the DTC.
5. With the scan tool, read ESL DTCs.
  Did the DTC reset?
  
  Yes
  - Go to 2
  No
  - Perform the TESTING FOR AN INTERMITTENT CONDITION procedure. Refer to TESTING FOR AN INTERMITTENT CONDITION .
CHECK RELATED HARNESS CONNECTIONS
1. Disconnect all ESL Module harness connectors.
2. Disconnect all related in-line harness connections (if equipped).
3. Disconnect the related component harness connectors.
4. Inspect harness connectors, component connectors, and all male and female terminals for the following conditions:
  - Proper connector installation.
  - Damaged connector locks.
  - Corrosion.
  - Other signs of water intrusion.
  - Weather seal damage (if equipped).
  - Bent terminals.
  - Overheating due to a poor connection (terminal may be discolored due to excessive current draw).
  - Terminals that have been pushed back into the connector cavity.
  - Perform a terminal drag test on each connector terminal to verify proper terminal tension.
  Repair any conditions that are found.
5. Reconnect all ESL Module harness connectors. Be certain that all harness connectors are fully seated and the connector locks are fully engaged.
6. Reconnect all in-line harness connectors (if equipped). Be certain that all connectors are fully seated and the connector locks are fully engaged.
7. Reconnect all related component harness connectors. Be certain that all connectors are fully seated and the connector locks are fully engaged.
8. With the scan tool, erase DTCs.
9. Using the recorded Environmental Data, along with the When Monitored and Set Conditions above, operate the vehicle in the conditions that set the DTC.
10. With the scan tool, read ESL Module DTCs.
  Did the DTC return?
  
  Yes
  - Replace the Electronic Steering Lock (ESL) Module in accordance with the Service information. Refer to MODULE, ELECTRONIC STEERING LOCK (ESL), REMOVAL AND INSTALLATION .
  - Perform the Electronic Steering Lock (ESL) Verification Test. Refer to ELECTRONIC STEERING LOCK (ESL) VERIFICATION TEST .
  No
  - Perform the Electronic Steering Lock (ESL) Verification Test. Refer to ELECTRONIC STEERING LOCK (ESL) VERIFICATION TEST .
  - Test complete.