LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2018 >> 300 C >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Cooling System >> Engine >> Pump, Water >> Installation >> 5.7L/6.4L

Pump, Water: Installation: 5.7L/6.4L

GC0137090Courtesy of CHRYSLER GROUP, LLC
  1. Clean and inspect the mating surfaces of the timing chain cover (1) and the water pump.
  2. Install the water pump (3). Tighten bolts (6) to the proper torque specifications. Refer to TORQUE SPECIFICATIONS .
  3. Install the upper stud bolt (2). Tighten bolt to the proper torque specifications. Refer to TORQUE SPECIFICATIONS .
  4. Install the lower radiator hose to the water pump.
  5. Install the upper radiator hose to the thermostat housing (1).
  6. Install the belt tensioner assembly (4). Tighten the bolt to the proper torque specifications. Refer to TORQUE SPECIFICATIONS .
  7. Install the idler pulley (5). Tighten the bolt to the proper torque specifications. Refer to TORQUE SPECIFICATIONS .
    GC0144611Courtesy of CHRYSLER GROUP, LLC
  8. Connect the temperature sensor wire hire harness connector (2).
  9. Using a new O-ring seal, install heater tube (3). Tighten bolt (1) to the proper torque specifications. Refer to TORQUE SPECIFICATIONS .
  10. Install the serpentine belt. Refer to BELT, SERPENTINE, INSTALLATION .
  11. Install the cooling fan assembly. Refer to FAN, COOLING, INSTALLATION .
  12. Install the air cleaner body. Refer to BODY, AIR CLEANER, INSTALLATION .
  13. Connect the negative battery cable.
  14. Evacuate the air and refill cooling system. Refer to STANDARD PROCEDURE .
  15. Check the cooling system for leaks. Refer to DIAGNOSIS AND TESTING .
scientia non olet · About LEMON Manuals