LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2018 >> 300 C >> Repair and Diagnosis >> External Pages >> Different car >> Section 2 (Electronic Control Modules (Service Information)) >> Module, HVAC >> Installation

Module, HVAC: Installation

WARNING: This page is about a different car, the 2018 Dodge Challenger. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

Illustration shown with instrument panel removed from view for clarity.

GC0144553Courtesy of CHRYSLER GROUP, LLC
  1. Position the Heating, Ventilation, and Air Conditioning (HVAC) module (1) to the air inlet housing (4) and engage the module to the two front retaining screws (2).
  2. Loosely install the screw (5) that secures the rear of the HVAC module to the air inlet housing.
  3. Tighten all the screws that secure the HVAC module to the air inlet housing.
  4. Connect the wire harness connector (3) to the HVAC module.
  5. Install the glove box. Refer to GLOVE BOX, INSTRUMENT PANEL, INSTALLATION .
  6. Connect the negative battery cable.
  7. Perform the HVAC Verification Test. Refer to STANDARD PROCEDURE .
scientia non olet · About LEMON Manuals