Sensor, Camshaft Position: Removal: 3.6L

Courtesy of CHRYSLER GROUP, LLC

CAUTION:

The magnetic timing wheels (1) must not come in contact with magnets (pickup tools, trays, etc.) or any other strong magnetic field. This will destroy the timing wheels ability to correctly relay camshaft position to the camshaft position sensor.

Courtesy of CHRYSLER GROUP, LLC

The Camshaft Position (CMP) sensors are located at the rear of the cylinder head covers and are bolted to the cylinder head.

Disconnect and isolate the negative battery cable.
Remove the engine cover.
If removing the left CMP sensor, first remove the air inlet hose and upper intake manifold (2). Refer to MANIFOLD, INTAKE, REMOVAL .

Courtesy of CHRYSLER GROUP, LLC

NOTE:
The right CMP sensor is shown in the illustration, the left CMP sensor is similar. If removing both right and left CMP sensors, mark the sensors so they can be installed in their original locations.
Disconnect the CMP sensor wire harness connector (1).

Courtesy of CHRYSLER GROUP, LLC
Loosen bolt (2) and Pull the sensor and mounting bolt from the cylinder head cover.
The O-ring seal (1) can be reused if not damaged.