Coil, Ignition: Installation: 5.7L/6.4L
CAUTION:
Do not apply a silicone based grease such as Mopar® Dielectric Grease to the ignition coil rubber boot. The silicone based grease will absorb into the boot causing it to stick and tear.
- Before installing coil(s), place a small, 360° bead of Uniflor 8172
lubricant (1) along the inside opening of the spark plug boots (1).
- Install the ignition coil into cylinder head and push both spark plug boots onto each spark plug.
- Install the two coil mounting bolts (3) and tighten to the proper torque specifications. Refer to TORQUE SPECIFICATIONS .
- Connect the ignition coil wire harness connector (1) to the coil and lock the connector.
- Install the engine cover.
- Connect the negative battery cable.