Installation - PDC Assembly

WARNING: This page is about a different car, the 2016 Chrysler 200. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Power Distribution Center, Power Feed Connections & Bolts

Courtesy of CHRYSLER GROUP, LLC

Position the upper PDC tray to the PDC base (3) in the engine compartment.
Connect the three bulkhead connectors (2) located in the base of the PDC to the upper PDC tray bottom.

Fig 2: Identifying Power Distribution Center, Power Feed Connections & Bolts
Courtesy of CHRYSLER GROUP, LLC
Tighten three screws (2) through the upper PDC tray until secure. Do not over tighten and crack the base or upper tray.
Connect all power feeds to their proper PDC posts.
Install the PDC cover onto the PDC assembly.
Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector to the negative battery cable.