Sensor, Knock: Installation: 5.7L/6.4L

Fig 1: Locating Knock Sensor

Courtesy of CHRYSLER GROUP, LLC

CAUTION:

Over or under tightening the knock sensor mounting bolts will affect knock sensor performance, possibly causing improper spark control.

NOTE:

The foam strip used on bolt threads is used only to retain the bolts to the sensors for plant assembly. It is not used as a sealant. Do not apply any adhesive, sealant or thread locking compound to these bolts.

Install the knock sensor (1) onto cylinder block. Tighten bolt (2) to the proper SPECIFICATIONS .
Connect the knock sensor wire harness connector (5).

Fig 2: Knock Sensor Heat Shield
Courtesy of CHRYSLER GROUP, LLC
Snap the heat shield (1) onto the knock sensor.

Fig 3: Lower Splash Shield & Fasteners
Courtesy of CHRYSLER GROUP, LLC
Install the belly pan and securely tighten bolts (1).
Connect the negative battery cable.