LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2016 >> 200 LX, Eng CD ED8 >> Repair and Diagnosis >> Electrical >> Body Electrical >> Power Distribution >> Module, Power Inverter >> Removal >> Removal

Module, Power Inverter: Removal: Removal

  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
    Fig 1: Upper End Of Floor Duct
    GC0162274Courtesy of CHRYSLER GROUP, LLC
  2. Unsnap the upper end of the floor duct (1) from the outlet on the left end of the heater and air conditioner distribution housing. Refer to DUCT, FLOOR DISTRIBUTION, REMOVAL .
  3. Remove the electrical connector from the Power Inverter Module (PIM).
    Fig 2: PIM Bracket Screw & Ventilation Door Motor
    GC0162332Courtesy of CHRYSLER GROUP, LLC
  4. Remove the screw (1) for the PIM bracket next to the ventilation door motor (2).
    Fig 3: PIM Bracket Arm Screw
    GC0162280Courtesy of CHRYSLER GROUP, LLC
  5. Remove the PIM bracket arm screw (1).
    Fig 4: Power Inverter Module Screws
    GC0162208Courtesy of CHRYSLER GROUP, LLC
  6. Remove the PIM and bracket from the vehicle.
  7. Remove both upper (1) and lower (2) screws to separate the PIM from the bracket.
scientia non olet · About LEMON Manuals