LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2015 >> 300 Limited, 4WD, Gas >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Engine Cooling System >> Engine >> Radiator, Engine Cooling >> Removal >> 3.6L

Radiator, Engine Cooling: Removal: 3.6L

  1. Disconnect the negative battery cable.
  2. Remove the air cleaner body. Refer to BODY, AIR CLEANER, REMOVAL, 3.6L .
  3. Drain cooling system. Refer to STANDARD PROCEDURE .
  4. Remove upper radiator hose.
  5. Remove cooling fan assembly. Refer to FAN, COOLING, REMOVAL .
  6. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
    Fig 1: Lower Engine Cover & Front Air Shield
    GC0144481Courtesy of CHRYSLER GROUP, LLC
  7. Remove the lower engine cover.
    Fig 2: Lower Radiator Hose
    GC0095212Courtesy of CHRYSLER GROUP, LLC
  8. Remove lower radiator hose (1).
  9. Lower the vehicle.
  10. Remove the front bumper fascia. Refer to FASCIA, FRONT, REMOVAL .
    Fig 3: Air Deflectors
    GC0144642Courtesy of CHRYSLER GROUP, LLC
  11. Remove the air deflectors (1).
    Fig 4: Upper Radiator Mounting Brackets Bolts
    GC0144643Courtesy of CHRYSLER GROUP, LLC
    CAUTION:

    Bolts are installed with threadlocker. Use hand tools to remove the upper radiator mounting bolts.

  12. Remove bolts (3) and the upper radiator isolator (1).
    Fig 5: Support Bolt
    GC0144644Courtesy of CHRYSLER GROUP, LLC
  13. Remove the lower condenser mounting bolts.
  14. Remove the bolt (2) located between the cooler lines.
  15. Using a suitable hanger. Support the condenser and remove the right side upper mounting bolt.
  16. Separate condenser assembly from radiator.
  17. Tilt radiator toward engine and remove radiator from vehicle.
scientia non olet · About LEMON Manuals