LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2014 >> 300 SRT-8 >> Repair and Diagnosis >> Suspension >> Wheel Alignment >> Front Suspension & Wheel Alignment >> Front >> Hub And Bearing >> Installation >> AWD

Hub And Bearing: Installation: AWD

Fig 1: Halfshaft Isolation Washer
GC0208659Courtesy of CHRYSLER GROUP, LLC
NOTE:

Before installing hub and bearing on end of axle half shaft, ensure isolation washer is present on end of half shaft. Inspect washer making sure it is not worn or damaged. Washer can be installed in either direction on shaft.

Fig 2: Locating Halfshaft AT Hub/Bearing Assembly
GC0079685Courtesy of CHRYSLER GROUP, LLC
  1. Slide hub and bearing (2) onto axle half shaft (1). Position hub and bearing onto knuckle, lining up mounting bolt holes.
  2. Install four bolts (3) fastening hub and bearing in place. Tighten mounting bolts to 68 N.m (50 ft. lbs.).
  3. Install brake rotor, then disc brake caliper and adapter assembly. Refer to ROTOR, BRAKE, INSTALLATION .
    Fig 3: Locating Axle Shaft Hub Nut
    GC0207775Courtesy of CHRYSLER GROUP, LLC
    NOTE:

    Always install a new hub nut. The original hub nut is one-time use only and should be discarded when removed.

  4. Install hub nut (1) on end of axle half shaft (2). While a helper applies brakes to keep hub from turning, tighten hub nut to 213 N.m (157 ft. lbs.).
    Fig 4: Tire And Wheel Mounting
    GC0079683Courtesy of CHRYSLER GROUP, LLC
  5. Install tire and wheel assembly (1). Refer to INSTALLATION .
  6. Lower vehicle.
    Fig 5: Reservoir Fluid Level Markings
    GC0094943Courtesy of CHRYSLER GROUP, LLC
  7. Pump brake pedal several times to ensure vehicle has a firm brake pedal before moving vehicle.
  8. Check and adjust brake fluid level in reservoir (1) as necessary.
  9. Road test vehicle and make several stops to wear off any foreign material on brakes and to seat brake pads.
scientia non olet · About LEMON Manuals