LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2014 >> 300 Base, 4WD, Gas/Ethanol >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Engine Cooling System >> Engine >> Radiator, Engine Cooling >> Removal >> 3.0L Diesel

3.0L Diesel

  1. Disconnect the negative battery cable.
  2. Remove the air cleaner body.
  3. Drain the cooling system. Refer to STANDARD PROCEDURE .
  4. Remove upper radiator hose.
    Fig 1: Cooling Fan Electrical Connector, Cooling Fan Mounting Bolts & Radiator Cooling Fan Assembly
    GC0144533Courtesy of CHRYSLER GROUP, LLC
  5. Remove radiator fan assembly (3). Refer to FAN, COOLING, REMOVAL .
  6. Raise the vehicle.
  7. Remove the belly pan.
    Fig 2: Lower Radiator Hose
    GC0095212Courtesy of CHRYSLER GROUP, LLC
  8. Remove lower radiator hose (1).
  9. Lower vehicle.
  10. Remove the front bumper fascia. Refer to FASCIA, FRONT, REMOVAL .
    Fig 3: Air Deflectors
    GC0144642Courtesy of CHRYSLER GROUP, LLC
  11. Remove the air deflectors (1).
    Fig 4: Upper Radiator Mounting Brackets Bolts
    GC0144643Courtesy of CHRYSLER GROUP, LLC
    CAUTION:

    Bolts are installed with threadlocker. Use hand tools to remove the upper radiator mounting bolts.

  12. Remove upper radiator mounting brackets bolts (3).
  13. Remove the upper radiator brackets (1) from the radiator supports (2)
    Fig 5: Support Bolt
    GC0144644Courtesy of CHRYSLER GROUP, LLC
  14. Remove the lower condenser mounting bolts.
  15. Remove the support bolt (2) located between the cooler lines.
  16. Using a suitable hanger. Support the condenser and remove the right side upper mounting bolt.
  17. Separate condenser assembly from radiator.
  18. Tilt radiator toward engine and remove radiator from vehicle.
scientia non olet · About LEMON Manuals