Steering System: Pump: Installation: Non-SRT

Fig 1: EHPS Pump Bracket Retaining Nut & EHPS Pump

Courtesy of CHRYSLER GROUP, LLC

If Electro Hydraulic Power Steering (EHPS) pump bracket (2) has been removed, install the bracket to the vehicle and tighten fasteners to 12 N.m (9 ft. lbs.).
Install EHPS pump (1) into vehicle and install EHPS bracket retaining nut (4). Tighten retaining nut to 12 N.m (9 ft. lbs.).

Fig 2: Two Mounting Bolts & Electro Hydraulic Power Steering (EHPS) Mounting Bracket
Courtesy of CHRYSLER GROUP, LLC
Install EHPS pump bracket (1) mounting bolts (2) and tighten to 50 N.m (37 ft. lbs.).
NOTE:
Always use a new O-ring on the end of the pressure line.
Lubricate the new O-ring on the end of the pressure line with clean power steering fluid.

Fig 3: Pressure Hose Retaining Bolt & (EHPS) Pump
Courtesy of CHRYSLER GROUP, LLC
Install power steering pressure line to EHPS Pump (3).
Install pressure line retaining bolt (2) and tighten to 10 N.m (89 in. lbs.).
Install EHPS pump electrical connectors (1).
Fill and bleed power steering system. Refer to STANDARD PROCEDURE .
Install right front wheelhouse splash shield Refer to SHIELD, SPLASH, FRONT WHEELHOUSE, INSTALLATION .
Lower vehicle.

Fig 4: Disconnecting/Connecting Battery Cables
Courtesy of CHRYSLER GROUP, LLC
Connect battery negative cable (2) to battery post. It is important that this is performed properly.