LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2013 >> 300 SRT-8 >> Repair and Diagnosis >> Accessories & Equipment >> Communication Devices >> Electronic Control Modules (Service Information) >> Module, Body Control >> Removal >> Removal

Module, Body Control: Removal: Removal

WARNING:

To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental airbag deployment.

  1. Disconnect and isolate the negative battery cable.
    Fig 1: Glove Box Assembly & Push Panel
    GC0144626Courtesy of CHRYSLER GROUP, LLC
  2. Remove the glove box assembly (1). Refer to GLOVE BOX, INSTRUMENT PANEL, REMOVAL .
  3. Remove the Instrument Panel lower hush panel (3).
    Fig 2: Body Control Module (BCM), Receptacles & Fasteners
    GC0144625Courtesy of CHRYSLER GROUP, LLC
  4. Disconnect the electrical connectors from the Body Control Module (BCM) (1) receptacles (2 and 3) as needed.
  5. Remove the fasteners (4) that secure the module, two at the bottom, and one at the top.
  6. Pull the module away from the side bulk head and down and remove the module.
  7. Remove the BCM from the vehicle.
scientia non olet · About LEMON Manuals