LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2013 >> 200 S, 2D Convertible >> Repair and Diagnosis >> General Information >> OEM General Information >> Circuit Testing Procedures - Non-DTC-Based Diagnostics >> Installation >> Installation

Circuit Testing Procedures - Non-DTC-Based Diagnostics: Installation: Installation

  1. Select a wire from the terminal repair kit that best matches the color and gage of the wire being repaired.
  2. Cut the repair wire to the proper length and remove one-half (1/2) inch of insulation.
  3. Splice the repair wire to the wire harness (see wire splicing procedure). Refer to STANDARD PROCEDURE .
  4. Insert the repaired wire into the connector.
  5. Install the connector locking wedge, if required, and reconnect the connector to its mating half/component.
  6. Re-tape the wire harness starting at 1-1/2 inches behind the connector and 2 inches past the repair.
  7. Connect battery and test all affected systems.
scientia non olet · About LEMON Manuals