Steering System: Pump: Removal: SRT

Fig 1: Disconnecting/Connecting Battery Cables

Courtesy of CHRYSLER GROUP, LLC

Disconnect and isolate battery negative cable (2) from battery post.
Siphon power steering fluid from pump reservoir.

Fig 2: Air Duct Retaining Clamp, Intake Air Temperature Sensor Electrical Connector, Makeup Air Hose, Bolt & Air Cleaner Housing
Courtesy of CHRYSLER GROUP, LLC
Loosen the air duct retaining clamp (1) at the throttle body.
Disconnect the intake air temperature sensor electrical connector (2).
Remove the makeup air hose (3) at the air cleaner housing.
Remove the air cleaner housing retaining bolt (4).
While lifting up the air cleaner housing (5), slide the air duct off the throttle body and remove the air cleaner housing from the vehicle.
Remove serpentine drive belt. Refer to BELT, SERPENTINE, REMOVAL .

Fig 3: Supply Hose, Pump, Remove Pressure Hose & Pump
Courtesy of CHRYSLER GROUP, LLC
Remove hose clamp, then supply hose (1) from pump (3).
Unthread tube nut, then remove pressure hose (2) from pump (3).

Fig 4: Power Steering Reservoir, Pump, Pulley & Bolts
Courtesy of CHRYSLER GROUP, LLC
Remove three pump mounting bolts (2) through access holes in pulley (3).
Remove pump (1) from engine.
If pulley needs removal. Refer to PULLEY, POWER STEERING PUMP, REMOVAL .