Isolator, Rear CROSSMEMBER, Spring Link: Removal: Removal

Raise and support vehicle. Refer to HOISTING, STANDARD PROCEDURE .
Access and remove rear spring on side of repair. Refer to SPRING(S), REMOVAL .

Fig 1: Headlamp Leveling Sensor
Courtesy of CHRYSLER GROUP, LLC
Export Only - If servicing right side bushing, disconnect headlamp leveling sensor (1) link at spring link (3).

Fig 2: Spring Link Mounting
Courtesy of CHRYSLER GROUP, LLC
Remove bolt and nut (1) fastening spring link (4) to crossmember.

Position spring link downward, away from bushing in crossmember.

Fig 3: Spring Link Bushing Removal

Courtesy of CHRYSLER GROUP, LLC

1 - BUSHING

2 - REMOVER 9032-2

3 - PRESS C-4212F

4 - RECEIVER 9032-1

NOTE:

Prior to using Press (3), Special Tool (special tool #C-4212F, Press, Ball Joint), lubricate screw-drive threads to provide ease of use and promote tool longevity.

Assemble tools over bushing as shown (See list). Ensure Receiver, Special Tool (special tool #9032-1, Receiver, Bushing), sets against crossmember and not welds.
- (2) Remover (special tool #9032-2, Receiver, Bushing)
- (3) Press (special tool #C-4212F, Press, Ball Joint)
- (4) Receiver (special tool #9032-1, Receiver, Bushing)
Tighten Press screw-drive, pressing bushing out of crossmember.