Throttle Body: Installation: 3.6L

Fig 1: Throttle Body-To-Intake Manifold Seal

Courtesy of CHRYSLER GROUP, LLC

Check the condition of the throttle body-to-intake manifold seal (1). The seal can be reused if not damaged.
Clean the mating surfaces of the throttle body and intake manifold.

Fig 2: Electrical Connector, Electronic Throttle Control (ETC), Clip & Mounting Bolts
Courtesy of CHRYSLER GROUP, LLC
Position the throttle body (2) to the intake manifold.
Install the throttle body mounting bolts (3) and tighten in a criss-cross pattern sequence to 7 N.m (62 in. lbs.).
Connect the electrical connector (1) to the Electronic Throttle Control (ETC) (2) and secure the ETC harness to the clip (4) on the throttle body.
Install the resonator. Refer to RESONATOR, AIR CLEANER, INSTALLATION .
Connect the negative battery cable and tighten nut to 5 N.m (45 in. lbs.).