PROGRAMING Procedure

WARNING: This page is about a different car, the 2011 RAM Pickup and 2011 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

Read all notes and cautions for programming procedures.

NOTE:

Have the vehicle PIN readily available to enter whenever prompted before running the routine.

CAUTION:

If the PCM and WCM are replaced at the same time, the PCM MUST be programmed before the WCM.

Connect a battery charger to the vehicle.
With the wiTECH diagnostic application, perform the following steps:

Select "WIRELESS CONTROL MODULE (WCM)"
Select the "MISCELLANEOUS FUNCTIONS" tab
Highlight "WCM REPLACED"
Select the "Start Misc Function" button
Select "NEXT"
Enter the PIN when prompted.
Select "NEXT"
Verify that the PIN number is correct
Once verified select "NEXT"
Select "NEXT"
Note On-Screen instructions and select the "FINISH" button
Cycle ignition key twice after the successful routine completion.