2.0L/2.4L Engine

NOTE:

Before proceeding. Refer to WARNING .

Fig 1: Pressure Hose

Courtesy of CHRYSLER LLC

Siphon as much fluid as possible from the power steering fluid reservoir.
Remove the engine appearance cover.
Remove the pressure hose (3) at the pump pressure port (5).
Remove the pressure hose routing bracket bolt (2) at the upper mount (8).
Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .

Fig 2: Return Hose AT Tube To Gear
Courtesy of CHRYSLER LLC
Remove the return hose (1) at the return tube (2) and allow any fluid in the hose to drain. If equipped with a screw-clamp, be sure to save the original clamp for reinstallation.

Fig 3: Identifying Pressure Hose Routing Clamp
Courtesy of CHRYSLER LLC
Remove the routing clamp screw (1) securing the pressure hose (2) to the right side of the crossmember (3).

Fig 4: Identifying Hoses AT Gear
Courtesy of CHRYSLER LLC
Unscrew the tube nut (3), then remove the pressure hose (4) at the steering gear.

Fig 5: View Of Hoses AT Rear Of Crossmember
Courtesy of CHRYSLER LLC
Remove the screws (1) securing the power steering hose routing clamps (2) to the rear of the crossmember (3).
Remove the power steering pressure hose from the vehicle.