LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 200 S, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 20 (5.7L Engine (Service Information)) >> Engine Block >> Cover, Structural Dust >> Installation >> Installation

Cover, Structural Dust: Installation: Installation

WARNING: This page is about a different car, the 2011 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Structural Dust Cover & Retaining Bolts
GC0145663Courtesy of CHRYSLER LLC
CAUTION:

The structural dust cover must be installed as described in the following steps. Failure to do so may cause severe damage to the cover.

  1. Position the structural cover (2) in the vehicle.
  2. Install the structural dust cover bolts (1) to the engine block finger tight.
  3. Install the structural dust cover bolts (1) to the transmission finger tight.
    CAUTION:

    The structural dust cover must be held tightly against both the engine and the transmission bell housing during the tightening sequence. Failure to do so may cause severe damage to the cover.

  4. Tighten the structural dust cover bolts to the transmission to 9 N.m (80 in. lbs.).
  5. Tighten the structural dust cover bolts to the engine block to 9 N.m (80 in. lbs.).
  6. Again, tighten the structural dust cover bolts to the transmission to 54 N.m (40 ft. lbs.).
  7. Again, tighten the structural dust cover bolts to the engine block to 54 N.m (40 ft. lbs.).
  8. Lower the vehicle.
scientia non olet · About LEMON Manuals