Diagnostic Test

CHECK FOR TCM TIPM DTCS
1. With the scan tool under TIPM, check for TCM Power Control DTCs.
  Are there any TIPM TCM Power Control DTCS present?
  
  Yes
  - Refer to DIAGNOSIS AND TESTING and perform the appropriate diagnostic procedure.
  No
  - Go To 2.
CHECK IF DTC P0883 IS CURRENT
1. With the scan tool, check the Starts Since Set counter.
  NOTE:
  This counter only applies to the last DTC set.
  
  Is the Starts Since Set counter set to 0?
  
  Yes
  - Go To 3.
  No
  - Go To 6.
CHECK THE (T16) TRANSMISSION OUTPUT CIRCUIT FOR A SHORT TO VOLTAGE

Fig 1: Checking Transmission Output Circuit For A Short To Voltage
Courtesy of CHRYSLER LLC
1. Turn the ignition off to the lock position.
2. Disconnect the PCM C1 harness connector.
3. Disconnect the TIPM C10 harness connector.
4. Ignition on, engine not running.
5. Measure the voltage of the (T16) Transmission Control Output circuits in the PCM C1 harness connector.
  Is the voltage above 0.5 of a volt on any (T16) Transmission Control Output circuit?
  
  Yes
  - Go To 4.
  No
  - Go To 5.
CHECK THE TRANSMISSION SOLENOID/TRS ASSEMBLY

Fig 2: Checking Transmission Output Circuit For A Short To Voltage
Courtesy of CHRYSLER LLC
1. Turn the ignition off to the lock position.
2. Disconnect the Transmission Solenoid/TRS Assembly harness connector.
3. Ignition on, engine not running.
4. Measure the voltage of the (T16) Transmission Control Output circuits in the PCM C1 harness connector.
  Is the voltage above 0.5 of a volt?
  
  Yes
  - Repair the (T16) Transmission Control Output circuit for a short to voltage.
  - Perform the TRANSMISSION VERIFICATION TEST. Refer to 62TE TRANSMISSION VERIFICATION TEST .
  No
  - Replace the Transmission Solenoid/TRS Assembly in accordance with the Service Information.
  - Perform the TRANSMISSION VERIFICATION TEST. Refer to 62TE TRANSMISSION VERIFICATION TEST .
CHECK THE (T15) TRANSMISSION CONTROL CIRCUIT FOR A SHORT TO VOLTAGE

Fig 3: Checking Transmission Control Circuit For A Short To Voltage
Courtesy of CHRYSLER LLC
1. Measure the voltage of the (T15) Transmission Control circuit.
  Is the voltage above 0.5 of a volt?
  
  Yes
  - Repair the (T15) Transmission Control circuit for a short to voltage.
  - Perform the TRANSMISSION VERIFICATION TEST. Refer to 62TE TRANSMISSION VERIFICATION TEST .
  No
  - Using the schematics as a guide, check the Powertrain Control Module (PCM) terminals for corrosion, damage, or terminal push out. Pay particular attention to all power and ground circuits. If no problems are found, replace and program the PCM in accordance with the Service Information. With the scan tool, perform Quick Learn.
  - Perform the TRANSMISSION VERIFICATION TEST. Refer to 62TE TRANSMISSION VERIFICATION TEST .
CHECK WIRING AND CONNECTORS
1. The conditions necessary to set this DTC are not present at this time.
2. Using the schematics as a guide, inspect the wiring and connectors specific to this circuit.
3. Wiggle the wires while checking for shorted and open circuits.
4. With the scan tool, check the Event Data to help identify the conditions in which the DTC was set.
  Where there any problems found?
  
  Yes
  - Repair as necessary.
  - Perform the TRANSMISSION VERIFICATION TEST. Refer to 62TE TRANSMISSION VERIFICATION TEST .
  No
  - Test Complete.