LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 200 Limited, 2D Convertible >> Repair and Diagnosis >> Engine Performance >> Ignition System (Service Information) >> Sensor, Camshaft Position >> Installation >> 2.0, 2.4L Rear

2.0, 2.4L Rear

Fig 1: Cam Sensor
GC0082375Courtesy of CHRYSLER LLC
CAUTION:

Install camshaft position (CMP) sensor utilizing twisting motion. Make sure CMP sensor is fully seated. Do not drive CMP sensor into the bore with mounting screw. This may cause CMP sensor to be incorrectly seated causing a faulty signal or no signal at all.

  1. Lubricate sensor O-ring.
  2. Install CMP sensor and mounting bolt and tighten to 9 N.m (79.5 in. lbs.).
    Fig 2: Rear Cam Sensor Shield Removed
    GC0082377Courtesy of CHRYSLER LLC
  3. Connect electrical connector to camshaft position sensor.
  4. Install heat shield onto mounting stud.
  5. Install heat shield retaining nut and tighten.
    Fig 3: Rear Cam Sensor Shield Installed
    GC0082376Courtesy of CHRYSLER LLC
  6. Connect the electrical connector.
  7. Connect negative battery cable.
scientia non olet · About LEMON Manuals