Charging System (Service Information): Generator: Removal: 3.5L

Fig 1: 3.5L GENERATOR ELECTRICAL CONN.

Courtesy of CHRYSLER LLC

CAUTION: Never force a belt over a pulley rim using a screwdriver. The synthetic fiber of the belt can be damaged.

1. Disconnect and isolate negative battery cable.
2. Remove generator drive belt. Refer to Cooling/Accessory Drive/BELT, Serpentine - Removal .
3. Unsnap plastic protective cover (4) from B+ mounting stud.
4. Remove B+ terminal mounting nut (3) and B+ terminal (2) at top of generator.
5. Disconnect field wire electrical connector (1) by pushing on connector tab.
   Fig 2: 3.5L GENERATOR R AND I

   Courtesy of CHRYSLER LLC
6. Remove short mounting bolt (3) from generator (1).
7. Remove long mounting bolt (2) from generator (1).
8. Remove generator (1) from engine mounting bracket.