Steering System: Pump: Removal: 2.7L/3.5L

Fig 1: BATTERY AND CABLES

Courtesy of CHRYSLER LLC

1. Disconnect and isolate battery negative cable (2) from battery post.
2. Siphon power steering fluid from pump reservoir.
3. Remove air cleaner housing and inlet tube to throttle body. Refer to Engine/Air Intake System/BODY, Air Cleaner - Removal
4. Remove serpentine drive belt. Refer to Cooling/Accessory Drive/BELT, Serpentine - Removal
   Fig 2: SUPPLY HOSE 3.5L

   Courtesy of CHRYSLER LLC
5. Remove hose clamp (2), then supply hose (3) from pump (1).
   Fig 3: PRESSURE HOSE AT PUMP - 3.5L

   Courtesy of CHRYSLER LLC
6. Unthread tube nut, then remove pressure hose (2) from pump (1).
   Fig 4: POWER STEERING PUMP - 3.5L

   Courtesy of CHRYSLER LLC
7. Remove three pump mounting bolts (1) through access holes in pulley.
8. Remove pump (3) from engine bracket (2).
9. If pulley needs removal. See Steering/Pump/PULLEY, Power Steering Pump - Removal .