MODULE, Steering Column Control: Removal: Removal: SCCM

Fig 1: SCCM MOUNTING

Courtesy of CHRYSLER LLC

1. Place the front road wheels in the STRAIGHT-AHEAD position.
2. Disconnect and isolate the negative battery cable.
3. Remove steering wheel. See Steering/Column/WHEEL, Steering - Removal .
4. Remove upper and lower steering column shrouds to gain access to the Steering Column Control Module (SCCM) (3). See Steering/Column/SHROUD, Steering Column - Removal .
5. Lock the clockspring rotor in the center position as follows: Insert a pin through the hole in the rotor at the 10 o'clock position.
6. Remove the three screws (1) to the SCCM.
   Fig 2: SCCM ELECTRICAL CONNECTORS

   Courtesy of CHRYSLER LLC
7. Disconnect the electrical connectors (2) between the SCCM (1) and the instrument panel wiring harness at the base of the SCCM and remove from column.