LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> Sebring Base, 2D Convertible, EDG >> Repair and Diagnosis >> External Pages >> Different car >> Section 9 (Electronic Control Modules (Service Information)) >> MODULE, Heated Seat >> Installation >> Installation

MODULE, Heated Seat: Installation: Installation

WARNING: This page is about a different car, the 2010 Dodge Avenger and 2010 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Locating Heated Seat Module
GC0082156Courtesy of CHRYSLER LLC
CAUTION: The Heated Seat Module mounting tab can be damaged during module removal and installation. Use care to properly align tab to prevent binding that could result in tab breakage.
  1. Install the heated seat module (3) into the vehicle.
  2. Position the retaining tab (2) with the mounting hole in the seat pan (1). Firmly apply even pressure to the module (3) until the mounting tab is fully seated.
  3. Connect the wire harness connector (4) to the heated seat module (3).
  4. Connect the battery negative cable.
  5. Check for proper heated seat system operation.
scientia non olet · About LEMON Manuals