Diagnostic Test

CHECK THE POWER AND GROUND CIRCUITS
1. This DTC is set when the PCM is initialized while the vehicle is moving in a valid forward gear. This is usually caused by a momentary loss of power to the Transmission portion of the PCM.
2. Check all of the Fused B(+), Fused Ignition Switch Output, and Ground circuits related to the PCM for an intermittent open or short to ground.
3. Perform a wiggle test on all wiring and connectors pertaining to the PCM while looking for shorted or open circuits.
4. With the scan tool, check the DTC EVENT DATA to help identify the conditions in which the DTC was set.
  View repair
  
  Repair
  - Repair as necessary.
  - Perform 40/41TE VERIFICATION TEST - VER 1. See DTC-Based Diagnostics/MODULE, Powertrain Control (PCM) - Standard Procedure