LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> Sebring Base, 2D Convertible, ED3 >> Repair and Diagnosis >> Transmission >> Automatic Trans >> (Automatic Transmission Control Module (TCM) - Electrical Diagnostics) >> Standard Procedure >> MPS6 Transmission Verification Test >> Diagnostic Procedure

Diagnostic Procedure

  1. Connect the scan tool to the Data Link Connector (DLC).
  2. Reconnect any disconnected components.
  3. With the scan tool, erase all Transmission and Engine Diagnostic Trouble Codes (DTCs).
    NOTE: Erase DTC P0700 under engine to turn off the MIL light after completion of transmission repairs.
  4. If the Transmission has been repaired (Valvebody/Controller replacment or if the Clutch assembly has been replaced), it is necessary to perform a Quick Learn (Teach-in) procedure with the scan tool.
  5. If the Powertrain Control Module (PCM), Front Control Module (FCM) or Totally Integrated Control Module (TIPM) has been replaced you must reset the Pinion Factor in the Front Control Module.
  6. With the scan tool, display Transmission Temperature. Start and run the engine until the Transmission Temperature is HOT, above 43° C (110° F).
  7. Check the transmission fluid and adjust if necessary. Refer to the Service Information for the Fluid Fill procedure.
  8. For a specific DTC, drive the vehicle to the symptoms When Monitored/Set condition(s) to verify the DTC is repaired.
  9. Check for any DTCs during and after the road test.

    Did any DTCs set during the road test?

    Yes 

    No 

    • Repair is complete.
scientia non olet · About LEMON Manuals