MPS6 Quick Learn Procedure

The quick learn procedure requires the use of the scan tool. This program allows the electronic transaxle system to recalibrate itself. This will provide the best possible transaxle operation.

• Transmission Control Module Assembly (includes controller, valve body and solenoid body) Replacement
• Dual Clutch Assembly Replacement
• Transmission Overhaul (Disassembly and Reassembly)

To perform the Quick Learn Procedure, the following conditions must be met:

• Shifter must be in P (park) position
• Park brake must be applied
• Service brake must be applied
• The engine must be running
• Transmission oil temperature must be above 18° C (64° F) and below 93° C (200° F)

1. Plug the scan tool into the diagnostic connector. The connector is located under the instrument panel.
2. Go to the Transmission screen.
3. Go to the Miscellaneous screen.
4. Select Quick Learn Procedure. Follow the instructions of the scan tool to perform the Quick Learn Procedure.