LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> Sebring Base, 2D Convertible, ED3 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 16 (Powertrain Control Module (Pcm) - Electrical Diagnostics - 41TE Automatic Transmission) >> DTC Troubleshooting >> P0733-Gear Ratio Error In 3RD >> Possible Causes

Possible Causes

WARNING: This page is about a different variant/trim than selected.
Possible Causes 
RELATED TRANSMISSION DTCS PRESENT
INPUT OR OUTPUT SPEED SENSOR ERRORS
LOW LINE PRESSURE
FAILED UD OR OD CLUTCH
CUT OR TORN UD OR OD CLUTCH PISTON SEAL
CUT UD OR OD ACCUMULATOR PISTON SEAL
STUCK MAIN REGULATOR VALVE
SOLENOID MODULE
BROKEN INPUT SHAFT
FAILED UD SHAFT
FAILED OD SHAFT
FAILED REAR PLANETARY GEARSET
FAILED FRONT CARRIER
FAILED REAR ANNULUS SHELL / SNAP RINGS

Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding. See  DTC-Based Diagnostics/MODULE, Powertrain Control (PCM) - Standard Procedure  .