HEATER, Engine Block: Installation: 2.0L/2.4L
WARNING: This page is about a different car, the 2010 Dodge Avenger and 2010 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
| 1 - BLOCK HEATER |
| 2 - POWER CORD |
- Thoroughly clean core hole and heater seat.
- Insert heater assembly with element loop positioned upward .
- With heater seated, tighten center screw securely to assure a positive seal.CAUTION: To prevent damage, the power cord must be secured in it's retaining clips, and not positioned so it could contact linkages or exhaust manifold.
- Connect power cord to heater.
- Lower vehicle.
- Fill cooling system. See Cooling - Standard Procedure .