LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> Sebring Base, 2D Convertible, ED3 >> Repair and Diagnosis >> External Pages >> Different car >> Section 10 (Starting System (Service Information)) >> Starter >> Removal >> 2.7L

Section 10 (Starting System (Service Information)): Starter: Removal: 2.7L

WARNING: This page is about a different car, the 2010 Dodge Avenger and 2010 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: HORIZONTAL BOLT
GC0120990Courtesy of CHRYSLER LLC
  1. Disconnect and isolate negative battery cable.
  2. Remove the front mount through bolt (1).
    Fig 2: ENGINE MOUNT/CROSS MEMBER
    GC0120991Courtesy of CHRYSLER LLC
  3. Remove lower engine anti-roll mount bolt (2)
  4. Remove crossmember mounting bolts (1).
    Fig 3: CROSSMEMBER REAR
    GC0120992Courtesy of CHRYSLER LLC
  5. Remove crossmember mounting bolts (1).
  6. Remove crossmember from vehicle.
    Fig 4: 2.7L TORQUE REACTION BRACKET
    GC0120993Courtesy of CHRYSLER LLC
  7. Remove torque reaction bracket transmission to starter bolt (1).
  8. Remove negative battery cable (2).
  9. Remove torque reaction bracket to transmission bolt (4).
  10. Remove torque reaction bracket to engine bolt (5).
  11. Remove torque reaction bracket (3) from vehicle.
    Fig 5: 2.7L EER ELECTRICAL CONNECTION
    GC0120994Courtesy of CHRYSLER LLC
  12. Remove battery cable nut (1), ignition sense wire (2) and battery cable (3) from solenoid stud.
  13. Disconnect electrical connector (4) from starter solenoid.
    Fig 6: 2.7L EER STARTER R AND I
    GC0120995Courtesy of CHRYSLER LLC
  14. Remove starter mounting bolts (1) from transmission housing (2).
  15. Remove starter motor (4) and dust shield (3) from transmission housing (2).
  16. Remove starter motor (4) from vehicle.
scientia non olet · About LEMON Manuals