LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> Sebring Base, 2D Convertible, ED3 >> Repair and Diagnosis >> External Pages >> Different car >> Section 10 (Starting System (Service Information)) >> Starter >> Installation >> 2.0, 2.4L

2.0, 2.4L

WARNING: This page is about a different car, the 2010 Dodge Avenger and 2010 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: STARTER ELECTRICAL CONNECTION
GC0084009Courtesy of CHRYSLER LLC
  1. Connect starter motor wiring. Tighten battery cable nut to 10 N.m (90 in. lbs.).
    Fig 2: ROTATE STARTER
    GC0082364Courtesy of CHRYSLER LLC
  2. Install starter motor into vehicle lower engine compartment.
    Fig 3: LOOSE STARTER THROTTLE BODY REMOVED
    GC0084010Courtesy of CHRYSLER LLC
  3. Loose install starter into position.
    Fig 4: THROTTLE BODY BRACKET
    GC0084008Courtesy of CHRYSLER LLC
  4. Install throttle body
  5. Install throttle body bracket.
    Fig 5: MOUNTING BOLTS
    GC0084006Courtesy of CHRYSLER LLC
  6. Install starter motor mounting bolts and tighten to 54 N.m (40 ft. lbs.).
    Fig 6: THROTTLE BODY ELECTRICAL CONNECTOR
    GC0084007Courtesy of CHRYSLER LLC
  7. Connect throttle body electrical connector.
  8. Install air cleaner box and inlet tube.
  9. Connect battery negative cable.
scientia non olet · About LEMON Manuals