Diagnostic Test

TEST FOR INTERMITTENT CONDITION
1. Turn the ignition on.
2. With the scan tool, record and erase the Diagnostic Trouble Codes (DTCs).
3. Cycle the ignition from on to off three times.
4. Turn the ignition on.
5. Using the scan tool, read the DTCs.
  Does the scan tool display this DTC as active?
  
  Yes
  - Go to Step 2.
  No
  - The conditions that caused this code to set are not present at this time. Using Figure as a guide, inspect the wiring and connectors.
  - Perform the BODY VERIFICATION TEST. Refer to DTC-Based Diagnostics/MODULE, Totally Integrated Power (TIPM) - Standard Procedure .
CHECK TIPM DTCS
1. Using the scan tool, read the TIPM DTCs.
  Does the scan tool display any CAN B BUS DTCs - ACTIVE?
  
  Yes
  - Refer to DTC-Based Diagnostics/MODULE, Totally Integrated Power (TIPM) - Diagnosis and Testing and perform the appropriate diagnostic procedure.
  No
  - Go to Step 3.
(D55) CAN B BUS (+) CIRCUIT OPEN

Fig 1: Measuring Resistance Of CAN B Bus (+) Circuit Between TIPM C5 Harness Connector & Memory Seat Module C1 Harness Connector
Courtesy of CHRYSLER LLC
1. Turn the ignition off.
2. Disconnect the Memory Seat Module C1 harness connector.
3. Disconnect the TIPM C5 harness connector.
4. Measure the resistance of the (D55) CAN B Bus (+) circuit between the TIPM C5 harness connector and the Memory Seat Module C1 harness connector.
  Is the resistance below 2.0 Ohms?
  
  Yes
  - Go to Step 4.
  No
  - Repair the (D55) CAN B Bus (+) circuit for an open.
  - Perform the BODY VERIFICATION TEST. Refer to DTC-Based Diagnostics/MODULE, Totally Integrated Power (TIPM) - Standard Procedure .
(D54) CAN B BUS (-) CIRCUIT OPEN

Fig 2: Measuring Resistance Of CAN B Bus (-) Circuit Between TIPM C5 Harness Connector & Memory Seat Module C1 Harness Connector
Courtesy of CHRYSLER LLC
1. Measure the resistance of the (D54) CAN B Bus (-) circuit between the TIPM C5 harness connector and the Memory Seat Module C1 harness connector.
  Is the resistance below 2.0 Ohms?
  
  Yes
  - Replace the Memory Seat Module in accordance with the Service Information.
  - Perform the POWER SEAT SYSTEM VERIFICATION TEST. See POWER SEAT SYSTEM VERIFICATION TEST .
  No
  - Repair the (D54) CAN B Bus (-) circuit for an open.
  - Perform the BODY VERIFICATION TEST. Refer to DTC-Based Diagnostics/MODULE, Totally Integrated Power (TIPM) - Standard Procedure .