Quick Connect Fittings: Connecting
- Inspect quick-connect fitting body and fuel system component for damage. Replace as necessary.
- Prior to connecting quick-connect fitting to component being serviced, check condition of fitting and component. Clean parts with a lint-free cloth. Lubricate with clean engine oil.
- Insert quick-connect fitting into fuel tube or fuel system component until built-on stop on fuel tube or component rests against back of fitting.
- Continue pushing until a click is felt.
- Single-tab type fitting: Push new tab down until it locks into place in quick-connect fitting.
- Verify a locked condition by firmly pulling on fuel tube and fitting (15-30 lbs.).
- Latch Clip Equipped: Install latch clip. If latch clip will not fit, this indicates fuel line is not properly installed. Recheck fuel line connection.
- Connect negative cable to battery.
- Start engine and check for leaks.