LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2008 >> Sebring Base, 4D Sedan, 2.7 R, Gas >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 20 (Power Transfer Unit) >> Power Transfer Unit >> Removal >> Power Transfer Unit

Power Transfer Unit

WARNING: This page is about a different variant/trim than selected.
Fig 1: Rear Transmission Bracket To Transmission Bolts
GC0060705Courtesy of CHRYSLER LLC
  1. Remove the rear transmission bracket to transmission bolts.
  2. Remove crossmember. Refer to REMOVAL .
  3. Remove right halfshaft assembly. Refer to REMOVAL .
  4. Remove the exhaust and rear maniverter from engine. Refer to REMOVAL .
  5. Remove propeller shaft assembly. Refer to REMOVAL .
    Fig 2: Heat Shield Bolts And Clips
    GC0060706Courtesy of CHRYSLER LLC
  6. Remove the one upper bolts (1) and clips (2) at the heat shield (3).
    Fig 3: Lower Heat Shield Bolt
    GC0060707Courtesy of CHRYSLER LLC
  7. Remove the lower heat shield bolt (2) and remove the heat shield (1).
    Fig 4: Removing/Installing Power Transfer Unit
    GC0050374Courtesy of CHRYSLER LLC
  8. Remove PTU-to-bracket lower bolts (2).
  9. Roll engine and transmission forward.
  10. Remove PTU (1) from vehicle.
scientia non olet · About LEMON Manuals