LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2008 >> Sebring Base, 2D Convertible, 2.4 K >> Repair and Diagnosis >> Engine Performance >> System >> Emissions Control System >> Air Injection >> Pump - Air >> Removal

Pump - Air: Removal

Fig 1: AIR INLET TUBE AT AIR PUMP
GC0072825Courtesy of CHRYSLER LLC
  1. Disconnect and isolate negative battery cable at battery.
  2. Remove air inlet tube (3) by pushing the ends (1) together, while pulling the air inlet tube (3) away from air pump housing connection (2).
    Fig 2: RELAY
    GC0072826Courtesy of CHRYSLER LLC
  3. Remove bolt (1) from heat shield (2) and air pump bracket (3).
    Fig 3: HEAT SHIELD
    GC0072827Courtesy of CHRYSLER LLC
  4. Remove heat shield bolt (1) and heat shield (3) from air pump bracket (2).
    Fig 4: PUMP TO BRACKET
    GC0072828Courtesy of CHRYSLER LLC
  5. Disconnect electrical harness connector (1) from the air pump electrical connector (2).
  6. Remove air pump mounting nuts (5) from bracket (4).
  7. Remove air pump (3) from bracket (4).
scientia non olet · About LEMON Manuals