LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2008 >> Crossfire 2D Convertible, Automatic >> Repair and Diagnosis >> Suspension >> Front Suspension >> Suspension System >> Wheel Alignment >> Standard Procedure >> Chassis Alignment Inspection

Chassis Alignment Inspection

  1. Observe the general information on chassis alignment inspection. See WHEEL ALIGNMENT .
  2. Drive the vehicle onto an electronic measuring system.
  3. Unlock the turntables and the sliding platforms.
  4. Install a brake pedal winch on the brake pedal.
  5. Attach the wheel sensors.
  6. Perform the initial measurement process.
  7. Inspect the vehicle level at the front and the rear axles and adjust if necessary. See CHECKING VEHICLE LEVEL .
  8. Inspect the vehicle level at the front and the rear axles with an electronic inclinometer and adjust if necessary. See INSPECTING AND ADJUSTING USING ELECTRONIC INCLINOMETER .
  9. Inspect and adjust the rear axle toe. See CHECK AND ADJUST REAR AXLE TOE .
  10. Inspect and adjust the front axle camber and caster. See CHECK AND ADJUST FRONT CASTER/CAMBER .
  11. Inspect the rear axle camber. See CHECKING REAR AXLE CAMBER .
  12. Inspect and adjust the front axle toe. See CHECK AND ADJUST FRONT TOE .
  13. Perform the final measurement of the vehicle.
  14. Detach the sensors.
  15. Remove the brake pedal winch.
  16. Carefully drive the vehicle off the measuring system.
  17. Lock the turntables.
scientia non olet · About LEMON Manuals